SMT Stencil Cleaning roll

SMT STENCIL CLEANROOM WIPER ROLLS DESCRIPTION: Stencil Wiping Rolls are used to remove residual solder paste from the bottom side of PC Board stencils. Using Stencil Wiping Rolls prevents smearing, bridging, and solder balls caused by normal printing of solder paste onto PC Boards.

We manufacturer Stencil rolls in a wide range of sizes to fit popular printer models including; DEK machines, Speedline machines, MPM machines, EKRA machines, Panasonic machines, SMTech machines, and Yamaha machines.

Most DEK printers use stencil rolls that are based on the same core tube, which is a plastic tube with a .75" inside diameter (19.5mm), that is 20.87" long (530mm). The typical roll outside diameter is 2.25", and it has 36 linear feet of paper per stencil roll. The full width roll has paper that is 20.12" wide (515mm), but some boards or printers are set up to accommodate a stencil roll with narrower width paper. It is important to make sure that when using a roll with paper that is not the full width that if a solvent bar system is being used, that the paper width is equal to or larger than the width of where the solvent is dispensed from the solvent bar.

Feature:

• Designed specifically for SMT screen printers
• Material adaptable for all vacuum and non-vacuum machines
• High strength, even when wet
• Exceptionally low lint levels
• Solvent resistant and highly absorbent

contact with Us